Tie Plug Cement

Concrete Repair

BSSP 10 Fosroc 18 Tarmac 4 Weber 7 DCP 6 Flexcrete 10 Ultracrete 3 Sika 4 Parex 5 Nufins 4 Ardex 6 Ronacrete 14

Concrete Treatments & Coatings

Surface Treatments 14 Concrete Coatings 15

Corrosion Prevention and Sealing

Corrosion Prevention 5 Viscotaq 5 Denso 4 Filoform 3

Expansion Joint Fillers

Gabion Baskets & Gabion Mattresses

Geotechnical

Ground Gas Protection

Monarflex 2 Visqueen 12 Juta 16 Cordek 5 RIW 7 Corden EPS

Grouts, Anchors & Formwork

Formwork 15 Grouts & Anchors 19

Highway Repair

Reinforcement Accessories

Wire Spacers 3 Concrete Spacers 5 Plastic Spacers 1 Tying Wire 2 Slab Accessories 5 Bolt boxes 3 Holding down bolts 1

Sealants & Adhesives

Adhesives 5 Arbo Sealants 6 BSSP Sealants 2 Everbuild Sealants 11 Expanding Foam 5 Sika Sealants 6 Fosroc Sealants 11

Site Consumables

Streetscape

Parex 4 Instarmac 3 Larsen 3 Steintec 3

Structural Waterproofing

TIEFILL is a single component, polymer modified, fibre reinforced, Portland cement based repair compound which exhibits unique hydraulic properties to produce a rapid setting curing mortar with enhanced polymer properties.

TIEFILL is ideally suited for the filling of voids, particularly in new construction, which needs to be rapidly put into service, such as tieholes, grout holes and voids around fixings.

Advantages

Incorporates the latest proven cement chemistry, polymer and fibre technology.
Pre-packaged materials in convenient pack sizes only requiring mixing with clean water on-site.
High bond strength exceeds tensile strength of concrete, thus ensuring monolithic performance.
Sets in 30 minutes at 20°C, yielding a durable, high strength mortar.
Waterproof seal which withstands 10 bar water pressure after only 72 hours curing.
Polymer modification gives enhanced adhesion and low permeability, providing excellent protection from acid gases, moisture ingress and chlorides.
Improved tensile and impact strength. Excellent low sag properties.
Non-toxic when cured and WRAS approved for use in contact with potable water.
Conforms with the requirements of Regulation 31(4)(b) Products with small surface area in contact with water.
Economic mortar generally requiring no substrate or inter-layer priming. Part bags can be mixed.